Pass Your Juniper JN0-343 Exam Easy!

passed today with 86%. Just 23 new questions. Until a "real" new dump is available, I would go for this one and try to answer the additional Questions as good as you can.

passed 94% still valid.

passed today with 95% dump still valid . .good luck

num of Q 70

I passed today with 100%. The dump is valid.
Those are correct answer which are difference from dumps.

Which Junos platform provides Ethernet Switching services?
A. M Series
B. T Series
C. EX Series
D. MAG Series

(C)


Which routing protocol is used for peering between autonomous systems?
A. OSPF
B. IS-IS
C. static routes
D. BGP

(D) BGP


Layer 2 interfaces can be assigned to operate in which two modes? (Choose two.)
A. route
B. access
C. trunk
D. distribution
( B,C )


What are two BGP session types? (Choose two.)
A. internal
B. inside
C. outside
D. external
(A,D)


Under wich hierarchy do you configure ospf?
a.edit protocols ospf
b.edit routing-options
c.edit routing-protocols
d.edit protocols-igp

(A)


Q 6: Which protocol provides redundancy in a LAN environment through the use of master and backup
routers?
A. BGP
B. BFD
C. VRRP
D. RIP

(C) (VRRP)

Thanks Zeeshan, Passed with 95%.

Just one new question and its regarding LAC.

this dump is 100% valid.

thanks to zeeshan ,i passed the exam with 92%

the dump is valid and I passed the exam with 95%.

This is solid for US test takers. Used this + the answers in these posts.

I also think that Q26 should be AC not AB.

Which two requirements are needed to load balance traffic per flow? (choose 2)

A a destination with equal cost paths
B a properly applied policy with an action to load-balance per-packet
C a properly applied policy with an action to load-balance per-flow
D a destination with multiple active roles

Ref: http://www.juniper.net/techpubs/software/junos/junos94/swconfig-policy/configuring-per-flow-load-balancing-based-on-hash-values.html#load-balance-per-flow-configuring

This Dump is valid i pass with 100%

Which Junos platform provides Ethernet Switching services?
A. M Series
B. T Series
C. EX Series
D. MAG Series

I think the answer is C. can somebody confirm this?

dump still valid pass with 94%

I passed today with 92%
Dump is totally valid

Which routing protocol is used for peering between autonomous systems?
A. OSPF
B. IS-IS
C. static routes
D. BGP

Correct answer is D BGP

I would like to confirm the answer of the next questions. I think these are the correct answers but I don't know but dump says..

Layer 2 interfaces can be assigned to operate in which two modes? (Choose two.)
A. route
B. access
C. trunk
D. distribution
( B,C )

What are two BGP session types? (Choose two.)
A. internal
B. inside
C. outside
D. external
(A,D)

Which routing protocol is used for peering between autonomous systems?
A. OSPF
B. IS-IS
C. static routes
D. BGP
(D)

What are two BGP session types? (Choose two.)
A. internal
B. inside
C. outside
D. external
(A,D)

Under wich hierarchy do you configure ospf?
a.edit protocols ospf
b.edit routing-options
c.edit routing-protocols
d.edit protocols-igp
(A)

Q 6: Which protocol provides redundancy in a LAN environment through the use of master and backup
routers?
A. BGP
B. BFD
C. VRRP
D. RIP

the answer is C (VRRP) and not A as said in the dump.

This is valid....passed easy but there are questions with wrong solutions. And one new question

Which three configuration settings under the [edit protocols stp] hierarchy on an EX Series switch allow this? (Choose three.)
A. max-age
B. bridge-priority
C. edge
D. forwarding-delay
E. hello-time
( A,D,E)
Layer 2 interfaces can be assigned to operate in which two modes? (Choose two.)
A. route
B. access
C. trunk
D. distribution
( A,D )

i passed withe 100%
1-c
2-ADE
3-BC
4-A
5-A
6-AD

Valid passed with 97%

Thank you Pablo. I not sure answer this below .

Which three configuration settings under the [edit protocols stp] hierarchy on an EX Series switch allow this? (Choose three.)
A. max-age
B. bridge-priority
C. edge
D. forwarding-delay
E. hello-time
( A,B,E)
Layer 2 interfaces can be assigned to operate in which two modes? (Choose two.)
A. route
B. access
C. trunk
D. distribution
( B,C )

1-c
2-ADE
3-AD
4-C
5-D
6-BC

I think these is the correct answer. I have doubts with the first one.

I'm not sure about answer of exam below. Pls help answer this questions.

Which Junos platform provides Ethernet switching services?
A. M Series
B. T Series
C. EX Series
D. MAG Series

Which three configuration settings under the [edit protocols stp] hierarchy on an EX Series switch allow this? (Choose three.)
A. max-age
B. bridge-priority
C. edge
D. forwarding-delay
E. hello-time

What are two BGP session types? (Choose two.)
A. internal
B. inside
C. outside
D. external

Which protocol provides redundancy in a LAN environment through the use of master and backup
routers?
A. BGP
B. BFD
C. VRRP
D. RIP

Which routing protocol is used for peering between autonomous systems?
A. OSPF
B. IS-IS
C. static routes
D. BGP

Layer 2 interfaces can be assigned to operate in which two modes? (Choose two.)
A. route
B. access
C. trunk
D. distribution

I not sure exam 110 questions enough for real exam ?

I am going to do the exam next friday. are there more questions than the 110 of this dump? Should I do the other dump of zeeshan with 367 questions?

I'm through with this exam JN0-343 tests, scores 97%
We Come

100% Valid passed with 90%

100% valid and this is all you need!
Juniper ActualTests JN0-343 v2012-12-08 by Zeeshan 110q.vce

@CertsLover can you please tell us if this VCE was helpful or the one before? How many questions in the real exam?

Zeeshan you are the MAN! It's right on the money!

Me too. wondering what's the difference between the other one and this except less questions..

What is the difference between this and the one posted previously besides less questions?

Thank you bro ¡¡¡
If someone goes to the exam with this dump, please let us know